Altman Spectra Cyc 100, Service & Parts Manual

Page: 12 / 45

Spectra Cyc LED Luminaires Service Manual
10
Maintenance Procedure
How to Replace the LED Driver Card on a Spectra Series CYC Fixture
Note: The following will show you how to take a SSCYC100 apart but the same can be done for the 50, 200 and 400
units.
The following Tools will be needed to complete this task
1 x Phillips Head Screwdriver
DANGER: Before beginning procedure BE SURE AC LINE POWER IS DISCONNECTED.
The following steps will walk you thru how to replace the LED Driver Card on a Spectra CYC.
Get access to the Rear Assembly of the Spectra Cyc.
Follow the steps on page 8 on how to Disassemble a Spectra CYC Fixture.
Unplug the 54-5435 Processor to Driver Harness as well as the 54-5915 P/S to Driver Harness. Figure 1
Unscrew the 4 screws holding in the driver board to the LED Processor Board. Figure 2
Once the screws have been removed, the board should be free to come out.
You will follow the same steps in reserve order to install the LED Driver Board
1.
2.
3.
4.
5.
54-5430 - Processor to Driver
Wire Harness
54-5915 - P/S to Driver Wire
Harness
Figure 1 Figure 2