PHX LED Ellipsoidal
Installation & User’s Manual
PAGE 13
INSTALLATION AND SET UP
POWER CONNECTION - DMX CONTROL MODE:
The PHX LED Ellipsoidal Luminaire should be connected to
either a constant circuit or relay device when in DMX mode. Note: Altman Lighitng recommends that all Non-
Dim circuits powering solid state luminaires are routinely powered down to both conserve energy and maxi-
mize luminare performance.
IMPORTANT AC POWER CONNECTION NOTES:
a. Must be supplied by a branch either dimming or constant circuit protected by a maximum 20 Amp circuit
protector.
Doit être alimenté par un circuit de dérivation protégé par un maximum de 20 ampères circuit protecteur.
b. When using the daisy-chain connection method, ONLY connect your PHX LED Elipsoidal to AC Output
Connection of other PHX LED Elipsoidals.
DO NOT CONNECT OTHER TYPES OF LUMINAIRES OR DEVICES!
c. Use only approved cable types.
d. Do not overload circuits!
f. The MAXIMUM allowable number of PHX LED Elipsoidals which can be 'daisychained' on one power feed-
CONNECTING POWER
should not exceed ratings.
DO NOT EXCEED!
Connecting Power
Units can be powered in one of two ways:
• Direct connection to a AC power source using a supplied AC input cable.
• Daisy chain connection using an interconnect AC cable.
Field wiring of PHX LED Elipsoidals Luminaire is straight forward. A total of 3 wires/conduc-
tors need to be brought to the unit. The following wiring scheme is required: Please consult:
http://www.neutrik.com/en/video/powercon/powercon-20-a/nac3fca
For additional powerCON blue and grey wiring and assembly information.
Wire Color
Purpose
Brown (230V) Black (120V)
Main/(L)ine (120 to 230 VAC)
Blue (230V) White (120V)
(N)eutral
Green/Yellow (230V) Green (120V)
Ground / Earth
WARNING!
The maximum allowable input current is 20 Amps (and the maximum power supply limit of 250
Watts for PHX2 and 150 Watts for PHX1). Do not overload circuits! Luminaires must be supplied by a branch
circuit protected by a maximum 20 Amp circuit protector. Doit être alimenté par un circuit de dérivation pro-
tégé par un maximum de 20 ampères circuit protecteur. Ne surchargez pas les circuits !
WARNING!
To prevent injury or death, you must have access to a main circuit breaker or other power disconnect device before installing
any wiring. Be sure that power is disconnected by removing fuses or turning the main circuit breaker off before installation. Installing the
device with power on may expose you to dangerous voltages and damage the device. A qualified electrician must perform this installation.
Note:
The PHX LED Ellipsoidal Luminaire is intended for installation in accordance with the National Electric Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before installation. The PHX LED Ellipsoi-
dal is not intended for residential use or installation.
