PNP415/417
PNP415/417
PNP415/417
PNP415/417
User’s Guide
400-0427-004
3
5. About Your PNP415/417
•
Customizable to almost any table top
•
Connector plates are fully compatible with PNP400 & PNP500 series
•
Holds up to eight connector plates
•
Smooth new look on all sides
•
Cutout always matches
•
Round, rectangular, or square cut-out
•
Simple, slide-in installation
•
Opens/closes by pressing on top
•
Gas spring lift mechanism
This Pop ‘N Plug uses a custom cut-out tabletop surface and hardware is attached underneath the cutout. When closed, the PNP415/417 lays flat and matches
the grain on your table.
ALTINEX provides three pre-configured templates for the PNP415/417 cutouts: round, rectangular, and square. A simple press on the lid closes the unit flush
with the tabletop.
The PNP415/417 design allows the connector panels to be easily installed. Just remove the top and slide the connector panels into place. In the open position,
the PNP415/417 is functional yet maintains a smooth, clean appearance.
The PNP417 comes preconfigured with two standard DS901-120 sectional plates. Each plate includes the following connections: two AC power, one 15-pin HD
(video), two RJ-45 (UTP), one RJ-11 (modem), and one 3.5mm audio. There are two plates and all connectors on the plates are female receptacles. Each signal
connector is connected via a 6-foot cable to its corresponding male plug at the opposite end. The AC power cables are terminated with standard NEMA plugs at
the end of 9-foot cords.
15-PIN HD VIDEO
3.5 mm AUDIO JACK
POWER
120VAC
RJ-11 PHONE JACK
RJ-45 NETWORK JACK
TABLE SURFACE
CUSTOM CUTOUT
