DISTRIBUTION AMPLIFIERS
2
PRECAUTIONS / SAFETY WARNINGS
1
Please read this manual carefully before using your
DA1406WM
Distribution Amplifier. Keep this
manual handy for future reference. These safety
instructions are to ensure the long life of your
DA1406WM
and to prevent fire and shock hazard.
Please read them carefully and heed all warnings.
1.1 GENERAL
•
Unauthorized personnel shall not open the unit
since there are high-voltage components inside.
•
Qualified Altinex service personnel, or their
authorized representatives must perform all
service.
1.2 SAFETY GUIDELINES FOR THE RACK-
MOUNTING OF THE DA1406WM
•
Maximum operating ambient temperature is 35
(degrees C).
•
Never restrict the air flow through the devices’
fan or vents.
•
When installing equipment into a rack, distribute
the units evenly. Otherwise, hazardous
conditions may be created by an uneven
weight distribution.
•
Connect the unit to a properly rated supply
circuit.
•
Reliable Earthing (Grounding) of Rack-
Mounted Equipment should be maintained.
1.3 INSTALLATION
•
For best results, place the
DA1406WM
Distribution Amplifier on a flat, level surface in a
dry area away from dust and moisture.
•
To prevent fire or shock, do not expose this unit
to rain or moisture. Do not place the
DA1406WM
Distribution Amplifier in direct
sunlight, near heaters or heat radiating
appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm
internal components.
•
Handle the
DA1406WM
Distribution Amplifier
carefully. Dropping or jarring can damage
internal components.
•
Do not place heavy objects on top of the
DA1406WM
. If the
DA1406WM
is to be mounted
to a table or wall, use only Altinex made
mounting accessories like brackets (
DA1293FC
and
DA1294FC
) and cables for optimum setup.
•
To turn off the main power, be sure to remove
the cord from the power outlet. The power outlet
socket should be installed as near to the
equipment as possible, and should be easily
accessible.
•
Do not pull the power cord or any cable that is
attached to the
DA1406WM
Distribution
Amplifier.
•
If the
DA1406WM
Distribution Amplifier is not
used for an extended period, disconnect the
power cord from the power outlet.
1.4 CLEANING
•
Unplug the
DA1406WM
power cord before
cleaning. Clean surfaces with a dry cloth. Never
use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.5 FCC / CE NOTICE
•
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
•
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
