TAEC Eco Owners Manual v2.5
w
w
w
.t
a
ec
.c
o
.n
z
3
Very important!
Please read the following instruction manual thoroughly before any
installation works or operation of the solar system proceeds! Failure to install
the equipment as detailed in this manual invalidates the warranty and could
endanger people and damage property.
The following safety warnings must be heeded: -
This appliance must be installed to our installation instructions, AS/NZS 3500, and to the
New Zealand Building Code G12 Water supplies.
The fixing of the solar panel and cylinder must comply with the current relevant selections
of the New Zealand Building Code and must not compromise the structural integrity of the
building.
Materials and fittings used to install this appliance must meet the requirements of AS/NZS
3500.4: 2003 Section 2.
The electrical installation of the equipment must comply with the current AS/NZ standards
and the New Zealand national electrical regulations.
The electrical input is: 240v~/50 Hz.
All hot water pipes must be installed to satisfy the requirements of New Zealand Building
Code Clause H1.3.4, (except where connected to a heat dissipation device).
The Eco Thermodynamic Solar System shall only be used for heating fresh water to the
temperature limits indicated.
The minimum permitted water pressure for use in the circuit is 100 kPa.
The maximum permitted water pressure for use in the circuit is 300 kPa.
This system must have a water softener installed if the water PH levels are less than 6.5 or
are greater than 8.5 as per AS/NZS 3500.4 Appendix B.
The Eco system shall must only be switched on once the hot water cylinder is filled with
water.
The Eco compressor
‘COMP’ must not be activated
before the installation has been
completed and the refrigerant supply has been fully loaded.
