Instruction manual 91/121 V6.3
Identification of the product
2 Identification of the product
2.1 CE marking and identification plate
The CE marking shall attest to the conformity of the apparatus with the essential health and safety requirements laid down in the
European Directives set out in the EC declaration of conformity. It consists of a silver polyester adhesive label with a black print, of
the following dimensions: L= 95 mm – H= 50 mm (Figure 1).
It is applied externally at the bottom (considering vertical panel mounting).
The following data are indicated in a legible and indelible way on the plate:
1) Technical data supply services.
2) Frequency range three-phase/mono-phase input voltage.
3) Three-phase/mono-phase input supply voltage.
4) Maximum current required (peak) from the three-phase
input.
5) Drive type.
6) Drive model (see encoding table on page 6).
7) Serial number (universal for each type of drive).
8) Firmware version of the product.
9) Maximum voltage output drive.
10) Maximum current (peak) dispensable from the drive.
2.2 Declaration of conformity
The
ALTER Elettronica S.r.l.
declares that, in the conditions specified in this document, the drives (CDM) model”PWM3D-001“, are
in conformity with the Community directives EMC, including the latest amendments, with the relative Italian transposition legislation
and the Community directives Low Voltage, including the latest amendments, with the relevant Italian transposition legislation.
Therefore, the CE marking, affixed to drives (CDM) model”PWM3D-001“, certifies compliance with both the EMC Directive and the
Low Voltage Directive.
2.3 Manufacturer’s declaration
The
ALTER Elettronica S.r.l.
for the purposes of the Machinery Directive (DM) 89/392 and subsequent amendments, with the relevant
Italian legislation transposing D.P.R. 459 of 1996-07-24, declares that the model drives”PWM3D-001“ must be installed according to
the instructions contained in this manual and shall not be put into operation until the machines in which they are incorporated have
been declared to comply with the DM Directive mentioned herein.
Alter Elettronica s.r.l.
5
Figure 1: Identification plate