Page-4
1. Using a ¼” drill bit, drill two holes into the rear of the enclosure at the locations
shown.
Drill Locations
Mounting the NP17AV Enclosure
The NP17AV enclosure can be either wall mounted using the supplied hardware
or pole mounted using the optional
NMK-0001
poll mounting kit available from
www.ALTELIX.com.
2. Using the included drilling template, place
in the desired mounting location and drill wall
as required.
3. Included with the enclosure are (4) Rubber
Bonded Washers and (4) Screws with Wall
Anchors.
4. Place Rubber Bonded
washers onto the screws
as shown.
5. (4) Holes in each corner of the metal back
plate provide access to the mounting holes in
the enclosure. When mounting, ensure the
rubber bonded washers complete cover the
enclosure mounting holes to provide a water-
tight seal.
Top of Enclosure
Altelix LLC USA: 866-660-WIFI (9434) International: +1 561-660-9434 [email protected] www.altelix.com
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See
www.altelix.com
for most current information
Back Plate
Access Hole
Enclosure
Mounting Hole
NP17AV Installation Guide
IS0107 Rev A 04/05/19
