LightStack™ UHD Plug and Play Fiber
Enclosure Instructions
TOOL
1
2
Front Cable Manager
Note: Protruding installation is not compatible with FrontCable Manager
Page 1: ...LightStack UHD Plug and Play Fiber Enclosure Instructions TOOL 1 2 Front Cable Manager Note Protruding installation is not compatible with Front Cable Manager ...
Page 2: ...Cable Manager Note The edge of Front Cable Manager should align with the edge of Enclosure 1 2 Protection tape 4 places Retro Fit Front Cable Manager Do not remove the protection tape before Front Cable Manager is securely attached and the mounting screws have been tightened see step 3 ...
Page 3: ...r by pulling out the latches on both sides allowing full access to LC ports in the front of the panel 6 Labeling 4a Use push pull feature to remove jumper Use with Siemon LC BladePatch Jumpers 4b Use with Siemon FJ2 J2 LC Jumpers Use a 3rd party extraction tool to remove jumper ...
Page 4: ...minals unless the circuit has been disconnected C Never install this device in a wet location D Never install wiring during a lightning storm 2021 Siemon Rev A XX XX 100 27670 00 LightStack UHD Plug and Play Fiber Enclosure Instructions 9 Rear Cable Management Mounting holes for Rear Cable Manager Apply slight side pressure on mounting tabs as inserted into the mounting holes Apply slight side pre...
