59
+31(0)78 - 615 20 33
[email protected]
www.altec.nl
+32(0)2 - 270 34 88
[email protected]
www.altec.be
NL
BE
Skip labels when printing
•
Label size is not specified properly.
•
Sensor sensitivity is not set properly.
•
The media sensor is covered with
dust.
•
Check if label size is setup correctly.
•
Calibrate the sensor by Auto Gap or
Manual Gap options.
•
Clear the GAP/Black mark sensor by
blower.
Wrinkle problem
•
Print head pressure is incorrect.
•
Ribbon installation is incorrect.
•
Media installation is incorrect.
•
Print density is incorrect.
•
Media feeding is incorrect.
•
Please refer to the chapter 5.
•
Please set the suitable density to
have good print quality.
•
Make sure the label guide touch the
edge of the media guide.
RTC time is incorrect when
reboot the printer
•
The battery has run down.
•
Check if there is a battery on the
main board.
The left side printout
position is incorrect
•
Wrong label size setup.
•
The parameter Shift X in LCD menu
is incorrect.
•
Set the correct label size.
•
Press [Menu]
[Setting]
[Shift X]
to fine tune the parameter of Shift X.
The printing position of
small label is incorrect
•
Media sensor sensitivity is not set
properly.
•
Label size is incorrect.
•
The parameter Shift Y in the LCD
menu is incorrect.
•
The vertical offset setting in the
driver is incorrect.
•
Calibrate the sensor sensitivity
again.
•
Set the correct label size and gap
size.
•
Press [Menu]
[Setting]
[Shift Y]
to fine tune the parameter of Shift Y.
Summary of Contents for ATP3000
Page 1: ...Version 1 0 User manual...
