6
MTX-416 - PROGRAMMABLE 4x16 INTERCOM MATRIX
3. WORKING PRECAUTIONS
The manufacturer is not responsible of any damage that can possibly happen to the unit outside
the limits of the warranty or those produced by not taking care with the working precautions.
Mains voltage must be between the limits of the admitted power supply (90-264 VAC, 50-60 Hz)
and that the fuse must be the appropriate (2A slow blow type: T2A). Damage caused by connection
to improper AC voltage is not covered by any warranty.
DANGER:
Inside the unit there are high voltages, do not open it. The unit does not
contain elements that could be repaired by the user. Whenever the unit is connected to
the mains, it carries elements with high voltages. In order to disconnect the unit
completely, you must disconnect it from the mains.
CAUTION:
Protect the unit from the rain and moisture. Ensure that no objects or
liquids enter it. If liquid is spilled into the unit, disconnect it from the mains and consult a
qualified service technician.
Do not place the unit close to heat sources.
4. INSTALLATION
UNPACKING
Before leaving the factory, each intercom matrix has been carefully inspected and tested.
Unpack and inspect the unit for any damage that may have occurred during shipment. If any
damage is found, does not connect the unit to the mains; notify the salesperson immediately; a
qualified service technician should inspect the unit.
Save the original packing, you could use if you need to transport the unit.
NEVER SHIP THE
INTERCOM MATRIX WITHOUT ITS ORIGINAL PACKING.
MOUNTING
It is always recommended to mount the unit in rack, either for mobile or fixed installations, for
protection, safety, aesthetics, etc.
The ALTAIR MTX-416 is designed for standard 19" rack mounting, and takes up 1u high rack
space.
CHANGING THE FUSE
This unit incorporates an internal, worldwide voltage operation power supply, and it is
prepared to work from 90 to 264 VAC, 50-60Hz.
Make sure that the unit is disconnected from the mains.
In the unit rear panel are placed the mains connector, the mains selector and the fuse holder.
The box bellows this mains connector is called fuse holder. Take out the fuse holder.
Summary of Contents for MTX-416
Page 10: ...10 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 12x16 MATRIX 16x16 MATRIX...
Page 11: ...11 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 4x32 MATRIX 4x48 MATRIX...
Page 12: ...12 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 4x64 MATRIX 8x32 MATRIX...
Page 18: ...18 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 8 BLOCK DIAGRAM...
