16
MTX-416 - PROGRAMMABLE 4x16 INTERCOM MATRIX
MEMORY CLEAR SWITCH
By means of the memory CLEAR switch, we can reset the working memory, so that in
normal mode, all the lines are disconnected of the channels, and in reverse mode all the
channels are disconnected of the lines.
When pressing the memory CLEAR switch, the display
will indicate YES? blinking, as well as the LED corresponding to
the CLEAR switch, indicating that we are in memory clear
mode.
The unit reset the memory clear mode if we do nothing or press a switch other than ENTER, in
a few seconds.
If we pressed the ENTER switch, the working memory will erase, disconnecting all the lines of
the channels in normal mode, or all the channels of the lines in reverse mode.
REVERSE MODE SWITCH
When pressing this REVERSE mode switch, we can change the working mode, 4 IN x 16
OUT in NORMAL mode or 16 IN x 4 OUT in REVERSE mode.
In format 4 IN x 16 OUT, each one of the sixteen lines
(OUT) can be connected to one of the four channels (IN).
In format 16 IN x 4 OUT, each one of the four channels
(OUT) can be connected to one of the sixteen lines (IN).
When pressing the REVERSE switch, the display will indicate YES? blinking, as well as the LED
corresponding to the REVERSE switch, indicating that we are in reverse mode change.
The unit reset the reverse mode change if we do nothing or press a switch other than ENTER,
in a few seconds.
If we pressed the ENTER switch, we will change the mode: If we were in NORMAL mode we
will turn to REVERSE mode and vice versa.
In REVERSE mode, the REVERSE LED will remain turned on, indicating to us that the unit is
configured in REVERSE mode.
6. OPTIONS
In this section we will explain the different available options for the intercom matrix ALTAIR
MTX-416.
SECURITY COVER (TP-1)
In some installation, it may be necessary to tamper proof the front panel controls avoiding
unwanted or accidental manipulations. For this purpose, it is available as an option, a transparent
plastic security cover. The installation is very easy, only with two provided screws.
7. SPECIAL OPERATIONS
In order to set-up some of the intercom matrix possibilities, the unit must be opened removing
the eight screws of the unit top cover
NOTE:
This type of operations takes place with the unit is opened; the best thing should be to carry it
out by a qualified technician.
Summary of Contents for MTX-416
Page 10: ...10 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 12x16 MATRIX 16x16 MATRIX...
Page 11: ...11 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 4x32 MATRIX 4x48 MATRIX...
Page 12: ...12 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 4x64 MATRIX 8x32 MATRIX...
Page 18: ...18 MTX 416 PROGRAMMABLE 4x16 INTERCOM MATRIX 8 BLOCK DIAGRAM...
