13
Altai Technologies Ltd. All rights reserved
Altai A3-Ei Dual-band 3x3 802.11ac Wi-Fi Access Point
Installation Guide
5.
Electrostatic Discharge (ESD) Protection
Electrostatic discharge (ESD) can damage electronic components and
cause latent damage that results in premature failure even if
components remain functional. In addition, the equipment must be
properly grounded. Technicians should always wear proper ESD
grounding straps connected to the ESD connector during equipment
installation, maintenance and repairs.
6.
Post Installation Procedures
Make sure that all cables are connected properly with the following
procedures after completing the A3-Ei installation and aligning the
antenna:
Make sure the antenna is mounted tightly after the alignment
Make sure the grounding strap is connected properly to the
ground.
Check all cables are connected to PoE injector correctly and
properly.
o
Make sure the Ethernet cable from PC or backhaul
network equipment is connected to “Data In” port of PoE
injector.
o
Make sure the Ethernet cable from A3-Ei is connected to
“Data & Power Out” port of PoE injector.
Make sure the PoE injector’s light is on.
Make sure the right cables are used during the installation
Make sure all connectors are sealed with the waterproof seal
properly.
After going through the above procedure, it is necessary to test the
wireless quality and check whether the RSSI fails into the acceptable
range or not via A3-Ei Web UI. It might be needed to re-aligns antenna
again if the performance is not acceptable.
