8. Commissioning
GEM80-400
Page 8-14
ALSPA GEM
80-400 SERIES CONTROLLERS TECHNICAL MANUAL
Issue 3 04/99
8.18.
Processor Modules fitted with FIP Interface Facility
If the processor is fitted with the FIP Interface facility then consult the FIP Manual
T1653.
Some older controllers were fitted with separate FIP Interface modules. If
attempting to fit an Interface board then the User Instructions sheet contained
with the Interface should be followed. The same precautions are required as for
fitting a Memory Expansion Module
8.19.
A Few Final Comments
In the preceding paragraphs, we have not been able to tell you how to
commission every type of unit or module you might have in your GEM
80 system.
However, we hope we have given you a sufficient introduction to commissioning
for you to be able to see how, with the help of User Information Sheets and
Manuals for particular products, you can commission any modules and units that
have not been mentioned.
