Alpine DVA-7996R, Owner'S Manual

Page: 11 / 69

9
-EN
Setting the Treble Control
You can change the Treble Frequency emphasis to
create your own tonal preference.
1
Press the CENTER f button to select the TREBLE
(treble centre frequency) control mode.
2-1
Setting the treble centre frequency:
Press DN or UP button to select the desired
treble centre frequency.
Emphasizes the displayed Treble frequency ranges.
Adjusting the built-in Crossover
The High and Low Pass Filters on this unit can be
adjusted to suit your personal taste.
1
Press and hold the X-OVER button for at least 2
seconds.
∗
When the subwoofer output of this unit is turned
OFF, LPF and phase are deactivated.
2
Press the DN or UP button to select the
desired setting.
1. HPF (Setting the High Pass Filter):
FLAT (OFF)
↔
80Hz
↔
120Hz
↔
160Hz
Outputs all frequencies higher than that selected
according to your preference.
2. LPF (Setting the Low Pass Filter):
FLAT (OFF)
↔
80Hz
↔
120Hz
↔
160Hz
Outputs all frequencies lower than that selected
according to your preference.
(Only available when using the subwoofer output from
this unit.)
NOTES
•
If HPF, LPF, Bass Control and Treble Control are all set to
ON, depending on the Bass Control and Treble Control
settings, you may not be able to reinforce the sound effect.
•
Except when the HPF and LPF is turned OFF, the subwoofer
is in monaural mode.
•
When the subwoofer is set to OFF, LPF mode and change of
phase does not work.
•
If no buttons are pressed within 15 seconds, the display for
setup menu disappears while an ordinary menu appears on
the display.
•
These functions are inoperative when an external, Ai-NET
processor is connected.
2-2
Setting the treble Level:
Turn the Rotary encoder to select the desired Treble
Level (–7~+7).
You can emphasize the treble frequency.
NOTES
•
If no buttons are pressed within 15 seconds, the Treble control
setting will be turned off automatically.
•
The settings of the Treble Level will be individually
memorized for each source (FM, MW (LW), CD, etc.) until the
setting is changed. Once you set Treble frequency for one of
sources (FM, MW (LW), CD, etc.), this setting becomes
effective for all those sources.
•
This function is inoperable when DEFEAT is ON.
BASS TREBLE normal mode
10.0kHz 12.5kHz 17.5kHz 15.0kHz
HPF
<Press for at least 2 seconds>
normal mode
<Press momentarily> <Press momentarily>
LPF
∗