Alpine DVA-7996R, Owner'S Manual

Page: 10 / 69

8
-EN
Setting the Bass Control
You can change the Bass Frequency emphasis to
create your own tonal preference.
1
Press the CENTER f button to select the BASS (bass
Centre frequency) control mode.
2-1
Setting the bass Centre frequency:
Press the DN or UP button to select the
desired bass centre frequency.
Emphasizes the displayed Bass frequency ranges.
2-2
Setting the bass Band Width (Q-Factor):
Press the BAND button to select the desired bass
Band Width.
Changes the bass boost band width to narrow or wide.
A wide setting will boost a wide range of frequencies
above and below the centre frequency. A narrower
setting will boost only frequencies near the centre
frequency.
2-3
Setting the bass Level:
Turn the Rotary encoder to select the desired bass
Level (–7~+7).
You can emphasize or weaken the bass frequency.
NOTES
•
If no buttons are pressed within 15 seconds, the Bass control
setting will be turned off automatically.
•
The settings of the Bass Level will be individually memorized
for each source (FM, MW (LW), CD, etc.) until the setting is
changed. Once you set Bass frequency and Bass Band Width
for one of sources (FM, MW (LW), CD, etc.), this setting
becomes effective for all those sources.
•
This function is inoperable when DEFEAT is ON.
Basic Operation
MODE (Rotary encoder)
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press the MODE (Rotary encoder) button repeatedly
to choose the desired mode.
Each press changes the modes as follows:
Volume : 0 ~ 35 Fader : R15 ~ F15
Balance : L15 ~ R15 Subwoofer : 0 ~ +15
NOTES
•
If the Rotary encoder is not turned in 5 seconds after
selecting the BALANCE, FADER, DEFEAT and
SUBWOOFER modes, the unit automatically sets in the
VOLUME mode.
•
*When subwoofer mode is OFF or when LINK (rear DVD
function (page 40) is set to ON), its level cannot be adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of
Bass, Treble will return to the factory defaults, but MX
will be turned off.
NOTE
Depending on the connected devices, some functions and display
indications do not work.
DN BAND
DISP/B.OUT
UP
X-OVER
CENTER f
BASS TREBLE normal mode
60Hz 70Hz 90Hz 80Hz
180Hz 150Hz 100Hz 130Hz
B. Width1 B. Width2 B. Width3 B. Width4
(Wide) (Narrow)
Blackout Mode On and Off
When the Blackout mode is turned on, the display will
turn off to reduce power consumption.
This additional power enhances the sound quality.
1
Press and hold the B.OUT button for at least 3
seconds to start the blackout mode. By doing so the
display will turn off.
NOTE
If any button on the unit is pressed during the blackout mode, the
function will be displayed for 5 seconds to show the operation
before returning to Blackout mode.
To cancel the blackout mode, press and hold the
B.OUT button for at least 3 seconds.
Changing the Audio Level Display
Pattern
You can select the display pattern mode from three
display patterns.
1
Press the DISP (DISPLAY) button to select the desired
Display pattern mode.
Each press changes the display patterns.
Pattern 1 Pattern 2 Pattern 3 OFF
BALANCE SUBWOOFER VOLUME
FADER
DEFEAT
∗