26
-EN
01GB05CDEW203E.fm
ALPINE CDE-W203E 68-14470Z10-A (EN)
Installation
• The main unit must be mounted within 30 degrees of the horizontal
plane, back to front.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
1
Remove the mounting sleeve from the main unit (see
“Removal” on page 26). Slide the unit into the
mounting sleeve and secure it.
Heat sink
Caution
Do not block the unit’s heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the
unit and may cause a fire.
Less than 30°
Mounting Sleeve
(Included)
Dashboard
Face Plate (Included)
This unit
Pressure Plates
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
*
1
) already
attached to the vehicle’s chassis.
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier to
the corresponding output lead coming from the left
rear of the CDE-W203E. Connect all other leads of
the CDE-W203E according to details described in
the CONNECTlONS section.
3
Slide the CDE-W203E into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
Screw
This unit
*
2
*
1
Bracket Keys
(Included)
This unit
01GB00CDEW203E.book Page 26 Monday, November 10, 2008 11:11 AM
Summary of Contents for CDE-W203E
Page 2: ......
