3
-EN
Never Attempt the Following
Do not grip or pull out the disc while it is being pulled back into
the player by the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power
is off.
Inserting Discs
Your player accepts only one disc at a time for playback. Do not
attempt to load more than one disc.
Make sure the label side is facing up when you insert the disc.
Your player will automatically eject any disc that is inserted
incorrectly. If the player continues to eject a correctly inserted
disc, push the Reset switch with a pointed object such as a
ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc or damage the player.
New Discs
As a protective measure to prevent the CD from jamming, the CD
player will automatically eject discs with irregular surfaces or
inserted incorrectly. When a new disc is inserted into the player
and ejected after initial loading, using your finger, feel around the
inside of the centre hole and outside edge of the disc. If you feel
any small bumps or irregularities, this could inhibit proper
loading of the disc. To remove the bumps, rub the inside edge of
the hole and outside edge of the disc with a ballpoint pen or other
such instrument, then insert the disc again.
Irregular Shaped Discs
Be sure to use round shape discs only for this unit and never use
any special shape discs.
Use of special shape discs may cause damage to the mechanism.
Tape Slack
Check and make sure any slack in the tape is taken up before
inserting the tape into the unit. A loose tape can get caught in the
mechanism and cause damage to the unit and the tape itself.
Tighten the tape by inserting a pencil or a similar instrument into
the spindle hole and turn until all the slack has been taken up.
Excessively Thin Tape
C-120 type cassette tapes are not recommended for use in
automobile tape players.
Precision Tape Mechanism
Prevent any foreign objects from entering the cassette opening as
the precision mechanism and tape head may be damaged.
Never play dirty or dusty tapes – they can damage the tape head.
Tape Head Cleaning
Periodic cleaning (approximately every 20 hours of use) of the
tape head with a wet type head-cleaning cassette tape (available at
audio stores) is necessary for best performance.
Fuse Replacement
When replacing the fuse(s), the replacement must be of the same
amperage as shown on the fuse holder. If the fuse blows more
than once, carefully check all electrical connections for shorted
circuitry. Also have your vehicle's voltage regulator checked.
Installation Location
Make sure the CDA-W560EX will not be installed in a location
subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
Centre Hole
Bumps
Centre
Hole
New
Disc
Outside
(Bumps)
