33
-EN
9
Fuse Holder (10A)
!
Power Supply Connector
"
Right Front (+) Speaker Output Lead (Grey)
#
Right Front (–) Speaker Output Lead (Grey/Black)
$
Right Rear (–) Speaker Output Lead (Violet/Black)
%
Right Rear (+) Speaker Output Lead (Violet)
&
Left Rear (+) Speaker Output Lead (Green)
(
Left Rear (–) Speaker Output Lead (Green/Black)
)
Left Front (–) Speaker Output Lead (White/Black)
~
Left Front (+) Speaker Output Lead (White)
+
Ai-NET Connector
Connect this to the output or input connector of other
product (CD Changer, etc.) equipped with Ai-NET.
• You can input TV/video sound by connecting an optional Ai-NET/
RCA Interface cable (KCA-121B) to this component.
,
Ai-NET Cable (Included with CD Changer)
-
Subwoofer RCA Connectors
RED is right and WHITE is left.
.
RCA Extension Cable (Sold Separately)
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a clean, bare metal spot (remove any paint, grease or dirt if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors. Contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
1
Aerial Receptacle
2
Power Aerial Lead (Blue)
Connect this lead to the +B terminal of your power aerial, if
applicable.
• This lead should be used only for controlling the vehicle's power
aerial. Do not use this lead to remote-turn on an amplifier or a
signal processor, etc.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier.
4
Audio Interrupt In Lead (Pink/Black)
5
Illumination Lead (Orange)
This lead may be connected to the vehicle's instrument
cluster illumination lead. This will allow the backlighting of
the CDA-W560E to dim whenever the vehicle's lights are
turned on.
6
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)12V
only when the ignition is turned on or in the accessory
position.
7
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
8
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
