10715 Springdale Ave, Ste 4, Santa Fe Springs, CA 90670
l
Tel: 1-888-287-9228
l
Fax: 1-888-258-9183
l
E-mail: [email protected]
Installation Instructions
LED Curved-Basket Linear Wrap Luminaire
2
Surface Mounting Installation Steps:
1.
Remove the lens and Led module plate.
2.
For mounting, using the provided mounting holes on each end of the fixture housing.
3.
Make electrical connections according to code.
4.
Install the lens by hanging from end plate pins of the luminaire and rotate into position.
Flex the lens to engage end plate pins on opposite side of the luminaire. See A for details.
Wiring Diagram:
ON-OFF Wiring
Follow the wiring directions as in fig. 1.
1.
Connect the black fixture lead to the
LINE supply lead.
2.
Connect the white fixture lead to the
COMMON/NEUTRAL supply lead.
3.
Connect the GROUND wire from fixture
to supply ground.
0-10V Dimmable Wiring
Follow the wiring directions as in fig. 1.
1.
Connect the black fixture lead to the (+)
LINE supply lead.
2.
Connect the white fixture lead to the (-)
COMMON supply lead.
3.
Connect the GROUND wire from fixture
to supply ground. Do NOT connect the
GROUND of the dimming fixture to the
output.
4.
Connect the purple fixture lead to the
(V+) DIM lead.
5.
Connect the gray fixture lead to the (V-)
DIM lead.
CAUTION
1. Avoid direct eye exposure to the light source while it is on.
2. Account for small parts and destroy packing material, as these may be hazardous to children
3. Disconnect power and allow fixture to cool before changing bulb or handing fixture.
120-277v
Black(Line)
White(Neutral)
Green(Grd)
Purple(Dim+)
Grey(Dim-
)
Blue(-)
Red(+)
Dimming wire
to 0-10v IEC
compliant control
Lead wire to
LED load
C
A
C
