22
031-295-B0-001, Rev. B (11/2018)
2.0 Installation, continued
2.3.1 Installation
Verify the following are on hand before installation:
• Kit, Mounting, Wall (Alpha p/n 746-034-20)
• Customer-supplied mounting hardware
Tools required:
• 3/8" wrench and socket
• Stud finder
• Level
• Hand drill with 5/32" bit
1. Remove the lid and door of the enclosure and set aside.
2. Use stud finder to locate centers of two studs and mark.
3. Hold upper bracket to located centers and mark the two lower holes at this time.
4. Drill 4 5/32" pilot holes at the marks.
5. Use 4 3/4" x 2-3/4" lagbolts to fasten the bracket to the wall.
6. Attach the lower mounting brackets to the enclosure.
7. Attach the enclosure to the upper mounting bracket.
8. Mark the holes (on stud center) for the lower mounting brackets and drill 5/32" pilot holes.
9. Use the 1/4" x 1-1/2" lagbolts to secure lower brackets to the wall.
10. Installation complete. The enclosure is now ready for utility wiring and installation of equipment.
The populated cabinet will weigh approximately 240 lbs [109kg]. Direct mounting to wall studs is required.
CAUTION!
!
