11
C048-781-30 R01, Rev. B (01/2020)
4.8
4.8 Circuit Breaker Installation
Circuit Breaker Installation
ENSURE BREAKERS ARE IN THE OFF POSITION
BEFORE INSERTING THEM.
CAUTION!
The v30/30 distribution panel offers six removable breaker modules
that each can fit up to ten slimline breakers.
Step 1.
Lift up the front lid of the v30/30 to access the breaker module
compartment. Loosen the captive screws on the circuit
breaker module retaining brackets and then lift out of the way
(see Figure 9).
Step 2.
Insert slimline circuit breakers into the circuit breaker
modules, ensuring they are fully seated (see Figure 10).
Step 3.
Return the circuit breaker module retaining bracket into the
locking position, then tighten the captive screws.
4.9
4.9 Polarity Check
Polarity Check
The v30/30 includes a set of LED indicators inside of the panel to
ensure correct polarity of the input terminations (see Figure 11).
A green light indicates correct polarity, while a red light indicates
incorrect polarity. To view these LED indicators, lift up the front panel
door and look inside the top section of the panel.
4.10
4.10 Display Power
Display Power
The v30/30 ships with the display power in the OFF position by
default. When the panel is ready to be turned on, lift up the front
panel door and carefully reach into the top section of the panel and
flip the switch to the right (ON position). See Figure 12.
Note: this switch is located next to LED indicators described above
in Section 4.9.
Figure 9. Module Retaining Bracket
Figure 10. Circuit Breaker Installation
Figure 11. Polarity Check
Figure 12. Display Power
