TABLE OF CONTENT
Item
Page No.
1. Safety Precaution ........................................................................... 1
2. Parts Identification .......................................................................... 2 - 3
3. General Information ........................................................................ 4 - 5
4. Installation Procedure ..................................................................... 6 - 10
5. Technical Specifications ................................................................. 11
6. Operating Instructions .................................................................... 12
7. Maintenance ................................................................................... 12
8. Troubleshooting Guide ................................................................... 13
9. Customer Service Centre ............................................................... 14
Installation and maintenance work shall
only
be performed by a qualified
person, familiar with local code and regulation, and experienced with this
type of appliance.
All field wiring must be installed in accordance with the national wiring
regulation.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliances.
Do not
attempt to repair the appliance yourself.
The electrical water heater must be installed with a mono-directional
Pressure Relief Valve at the inlet pipe. The pressure relief device is to be
operated regularly to remove lime deposit and to verify that there is no
blockage.
The water may drip from the Discharge Pipe of the pressure relief device
and that this pipe must be left open to surrounding air. A Discharge Pipe
connected to the pressure-relief device is to be installed in a downward
direction and in a frost-free environment.
The electrical water heater must be prefitted with isolation barriers at both
inlet and outlet connections.
The heater must be permanently connected to the electricity supply through
a double-pole-linked switch with a contact separation of at least 3mm in
all poles incorporated in the circuit.
If the supply cord is damaged, it must be replaced by the manufacturer,
service agent or a similarly qualified personnel in order to avoid hazards.
In order to avoid hazards due to inadvertent resetting of the thermal cut-out,
this appliance can not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and
off by the utility.
1
SAFETY PRECAUTION
