Alpha One FALCON SPERBER mini DMX 2000W, Instructions For Use Manual

Page: 8 / 26

- 8 –
Version 2.0 November 2008
2.5 Standards, directives, regulations
Safety clearance
Position the equipment on a suitable base which corresponds to the requirements
in the specification for the searchlight in terms of size, weight and safety
clearances to be maintained.
Because of the danger of burns, it should be ensured that during operation nobody
touches the equipment. Also, while the position of the equipment is adjusted
hands, arms, or the head may be caught.
The requirements of standard DIN EN 349 "Safety of machinery; minimum gaps
to avoid crushing of parts of the human body" apply here.
Ventilation
The heat created by this searchlight can escape to a sufficient extent. Never install
the searchlight in a box or rack where there is insufficient ventilation. Never block
the openings in the equipment which are needed to allow heat to escape.
Never lean any objects against the equipment.
Maintain a clearance of at least 1.0 m around the equipment, so that the heat which
it creates can escape without hindrance.
Supply voltage
Operate the searchlight only at the mains voltage shown on the manufacturer's
plate.
Use only voltage supplies which correspond to the local and general safety
regulations, and are protected by overload protection and a leakage protection
switch. To protect against electric shock, ensure that the equipment is correctly
earthed.
The equipment should be connected to the supply voltage only after the
installation or replacement of the illuminant is complete.
Intended use
The searchlight is designed only for professional use, and its use under domestic
conditions is forbidden.
The FALCON
®
SPER
B
ER
®
mini DMX 2000W is permitted for use as a
DMX 512 controlled xenon searchlight for effect and event illumination and for
permanent installations.