Page 8
Eagle 800 Series II Service Manual
Rev. A00
After installing the DIMMs, the next time you power on the system, the memory will be detected.
Currently, the maximum memory available to AMOS is 750MB. This limitation is imposed by
memory utilization by the XP Embedded software. You may enter the AMOS RAM size in the
General
tab of the AM8000 configuration screen. It has a data input box with the current
allocation in MB displayed. We recommend the following memory configurations for the various
total available memory capacity:
Total Memory Installed AMOS
memory
128 MB
64 MB
256 MB
128 MB
512 MB
256 MB
1 GB
512 MB
2 GB
750 MB
PERIPHERALS
Your computer system cabinet can hold up to six peripherals, making a wide range of configurations
possible. The peripheral bays are structured as follows:
•
Three 5-1/4” front accessible bays typically used to mount tape backup devices, CDs, and other
5-1/4” removable media peripherals. Your writeable CD is mounted on one of these bays.
•
Two 3-1/2” front accessible bays, one used to mount a floppy diskette drive.
•
One 3-1/2” drive cage (lower cage) that can hold up to three 3-1/2” peripherals, all internally
accessible only. The main system disk is usually mounted in the bottom position of this drive
cage.
Installing Additional 3-1/2” Peripherals
Locate the 3-1/2” drive cage and determine the location you want to install the new peripheral. The
lower mounting tray allows a floppy disk drive to be mounted. The drive cage mounts disk drives that are
totally contained within the system chassis.
To mount peripherals requiring front panel access, follow the instructions below:
1. On the sides of the front bezel, there are two tabs. Press in the tabs and pull forward to remove the
top half of the bezel.
2. Unscrew the two silver thumbscrews located on the bottom of the drive bay assembly and slide out
the 3.5” drive bay assembly.
3. Usually, the floppy drive mounts in the floppy tray. Mount the other 5 1/4” devices into the top drive
bay.
4. Slide the whole assembly back into the case and fasten it with the thumbscrews.
