Aloka ProSound Alpha 10, Service Manual, Page: 35 / 405

MN2-2008, Rev.2
SECTION 4
Principle of System Operation
4 - 2
Display modes
Electronic
Linear/
Convex
Electronic
Sector
3D Convex
Sector
3D Phased
Array
Sector
Independent
CW
Mechanical
Sector
Mechanical
Radial
B, B-Zoom, 2B
" " " " $ " "
B (F), B (PF),
B(F)-Zoom,
B(PF)-Zoom
2B(F), 2B(PF)
" " " " $ $ $
4B(F), 4B(PF)
" " " " $ $ $
4B, B/M " " " " $ " (*1) $
B(F)/M(F)
B(PF)/M(PF)
" " " " $ $ $
B/PW Doppler
B(F)/PW Doppler
B(PF)/PW Doppler
" " " " $ $ $
B/CW Doppler
B(F)/CW Doppler
B(PF)/CW Doppler
$ "
(*1)
$ "
(*1)
$ $ $
M
" " " " $ " $
M(F), M(PF)
" " " " $ $ $
PW Doppler
" " " " $ $ $
CW Doppler
$ " $ " " $ $
B
(
VOL " $ " " $ $ $
B/VOL
$ $ " " $ $ $
"
: Possible,
$
: Impossible, (*1): No Duplex/Triplex
F: Flow, PF: Power Flow
- The EU-9110 is required for connection of Independent probe.
- The EU-9109 or EU-9124 is required for connection of Mechanical probe.
- The SOP-ALPHA-4 is required to use Real Time 3D function.
Probe Frequency
Electronic Probes Selection is possible by Image Freq.
Mechanical Probes Ver.4.0~ Selection is possible by Image Freq.
Independent Ver.3.0~ 2MHz, 5MHzTransmission Frequency
Electronic Probes 1.25MH
*
~ 13MHz
(Each probe has a frequency limit)
Ver.7.0~ Frequency is selectable for manual flash function
(the condition of Low MI/Flash type: strong only)
Mechanical Probes Ver.4.0~ 6.0MHz ~ 15.0MHz
(Each probe has a frequency limit)
Independent Ver.3.0~ 2.14MHz, 5MHz
(Each probe has a frequency limit)