Aloka ProSound Alpha 10, Service Manual, Page: 34 / 405

MN2-2008, Rev.2
SECTION 4 Principle of System Operation
4 - 1
4-1 System Specification
Scanning System Electronic Linear Scanning
Electronic Convex Scanning
Electronic Sector Scanning
1.5D Array Electronic Linear Scanning
Electronic Convex (3D) Scanning
(the SOP-ALPHA10-4 is required)
Ver.3~ Electronic Sector (3D) Scanning
(the SOP-ALPHA10-4 is required)
Ver.3~ Independent probe (the EU-9110 is required)
Ver.4~ Mechanical Sector Scanning
(the EU-9109 or EU-9124 is required)
Ver.4~ Mechanical Radial Scanning
(the EU-9109 or EU-9124 is required)
Ver.4~ Motorized trans-esophageal probe
Ver.5.1~ Olympus Ultrasonic Gastrovideoscope
(Convex sector type: the SOP-ALPHA10-17 is required)
(Electronic radial type: the SOP-ALPHA10-18 is required)
Simultaneously Attached Probes Electronic Probe ....... 4 probes
Ver.3~ Independent probe ....1 probe (the EU-9110 is required)
Ver.4~ Mechanical probe .....1 probe
(the EU-9109 or EU-9124 is required)
Operating Modes B (Fundamental, THE, CHE)
M (Include FAM)
D (PW Doppler, CW Doppler, STCW Doppler)
Flow (Velocity/Variance, Power Flow, TDI)
Ver.2.1~ eFlow (For Lite version, the SOP-ALPHA10-12 is required)
RT-3D (the SOP-ALPHA10-4 is required)
Ver.6.0~ Analog PW Doppler (the hardware is required)
M, D-mode Display Moving Bar Display (Scrolling is not available)
Sweep Speed: 7 steps
~Ver.4 (17.5, 11.6, 8.7, 5.8, 4.4, 2.9, 2.2 cm/sec)
Ver.5~ (200.0, 150.0, 100.0, 66.7, 50.0, 33.3, 25.0 mm/sec)
Possible on both real time and frozen image.
THE, CHE-mode Display THE (PHE, ePHD)
CHE (PHD, Harmonic Power Flow, ePHD)
Ver.7~ Transmission with selected MI value
Ver.7~ Direct select function to ePHD mode
Diagnostic Distance 0.5
+
30cm (Each probe has a diagnostic limit)
~Ver.4 1.0cm step (0.5cm step at 0.5cm ~ 2.0cm)
Possible to set selectable range up as each preset
Ver.5~ 0.5cm/0.75cm/1.0cm/1.5cm/2.0cm/2.5cm/3.0cm/
3.5cm4.0cm/4.5cm and 1.0 cm step at 5.0cm~.
Notes about expression:
The comments like “Ver.2~” in this document generally means the level
of system in combination of software and hardware. Therefore, some of
specification below may not be applied if only the software is
compatible.