Alnor HRU-SlimAIR-250, User Manual

Page: 45 / 64

!
Kacper.Szyku ł a
Zaprojektowany przez Sprawdzony przez Zatwierdzony przez Data
Materia ł
Skala
0,15 :
1
A2
Nazwa cz ęś ci
monta ż uniwersalny SlimAIR z odsuni ę ciem
i w ęż em odp ł ywu skroplin
Format Masa
Data Data
25.02.2021
Nie
dotyczy
3,
00
°
150
150
150
Kacper.Szyku ł a
Zaprojektowany przez Sprawdzony przez Zatwierdzony przez Data
Materia ł
Skala
0,15 :
1
A2
Nazwa cz ęś ci
monta ż uniwersalny SlimAIR z odsuni ę ciem
i w ęż em odp ł ywu skroplin
Format Masa
Data Data
25.02.2021
Nie
dotyczy
3,
00
°
150
150
150
!
!
45
ALNOR
®
systemy wentylacji
jest prawnie chronionym znakiem i technicznym patentem. Prawo do zmian zastrzeżone.
w
w
w
.al
nor
.com.
pl
Instrukcja obsługi
HRU-SlimAIR
NOTE!
Hang the unit on the frame from the OUTDOOR/EXHAUST side. This results from maintaining the
correct slope on the condensate drain side. Incorrect installation can lead to incorrect drainage
of condensate.
To install the siphon in position, carefully place the elastic pipe over the side condensate connector pipe. Make
a siphon using the elastic pipe and the clip (Fig.17). When the siphon is ready and connected to the waste
water system, level the unit accordingly. Fill the siphon with water immediately after making it.
Fig. 25 - Siphon installation in horizontally suspended position and pipe level
deviation
NOTE:
The wall plugs supplied are designed for concrete walls, solid bricks or cellular concrete. For other
materials, use suitable plugs or screws, which can be purchased from a hardware shop.
NOTE:
Remember to fill the siphon. If the siphon dries out, the condensate is not drained from the casing
(vacuum effect created by the running fans) and the water can leak through the casing or damage
the fan. Fill the siphon by pouring water directly into it.
Do not pour water into the extract duct connection!
Do not fill the siphon while the air handling unit is in operation!
Installation of the heat recovery unit does not require an angle. If there is space for it, an inclination of max.
3° from the bottom edge of the unit (irrespective of the type of installation) will have a positive effect on the
condensate removal from the unit.
If there is no space for a condensate drain trap, it is recommended to purchase a condensate pump, which
can be purchased from HVAC wholesalers.