Step 5. Bench and LED Backrest Installation continued
Center the LED Backrest between the two sides being sure it’s oriented so the shorter slat is down and position it vertically at a height most comfortable
for you (typically 8-12” from the bench). Using a level to ensure proper installation, fasten the backrest into place using the 2” screws. (Images 34 & 35)
To connect the LED light to the power source, bore a 5/8” hole through the back of the panel at the bottom right corner of the backrest and push the LED pigtail
through (Images 36 & 37). Now mount the power supply to the back of the sauna at the base of panel D, underneath the hole you just bored (Image 38). Connect
the power supply and LED pigtail (Image 39), and plug in the supply to an outlet. You are able to turn on the LED light and adjust its brightness from within the
sauna using the control mounted to the side of the backrest (Image 40).
Note: The lower side bench will be installed once the rest of the sauna is finished.
Step 6. Position Wall Sections F & Window Section G
Position Wall Section F into the groove of the side rail orienting it so that the heater vent holes are located at the
bottom
. Slide wall section F into
place with section E (Image 41). Section F connects to section E via tongue and groove so there is no need to use screws. Use a rubber mallet to
secure the fit (Image 42). Place window section G in the groove on the front rail (Image 43) and push the flat end against wall section F. Being
sure the two sections are flush, fasten them together using 2” screws through the pre-drilled holes (Image 44).
Image 38
Image 39
Image 34
Image 35 Image 36
Image 37
Image 40
Image 41 Image 42
Image 43
Image 44
BRIDGEPORT | BRAXTON SAUNA INSTALLATION MANUAL
page 4
