3
1. Connect the 4 FLOOR RISERS
Your existing floor will serve as
the floor for your sauna. The pre
-
fabricated rails and risers will be
placed on your existing floor and
provide the structural support for
the sauna room. The 4 floor risers
are pre
-
drilled and are assembled
with 2” screws. Use a framing
square to be sure the assembled
frame is square.
NOTE:
Be sure your surface is flat
before you begin assembly.
2. Connect the WALL SUPPORT
RAILS with groove facing up
The 4 wall support rails are as-
sembled with 2” screws. Use a
framing square to be sure the
frame is square. Draw the cor-
ners tight by angle screwing the
corners together.
NOTE:
One side of each rail is pre
-
drilled. After lining up the rails
and prior to screwing them to-
gether, it is suggested that you
pre
-
drill through the factory
-
drilled pilot hole into the second
rail using a 1/8” drill bit. Drill
about 1” into the second rail. This
will prevent the possibility of strip
-
ping or breaking the screw.
3. Position and Fasten WALL
SUPPORT RAILS
Place the assembled wall support
section on the assembled floor
section; be sure the groove is fac-
ing up. Using 2” screws, attach
the support rails to the floor ris-
ers. Use 4 screws for each rail.
The combined riser and rails is
now called the wall support sec-
tion.
ILLUSTRATION 1
The 9 wall sections, A– I, will be
positioned in the grooves of the
completed wall support section as
shown.
Completed
Wall
Support
A
B
C
D
E
F
G
H
I