2
Read this entire manual through to the end before proceeding with the assembly.
CHECK YOUR BOXES
Be sure to immediately check your boxes against your shipping list and bill of lading. Examine for any damage and notify Almost
Heaven Saunas if there needs to be a repair or replacement of damaged or missing materials.
ELECTRICAL REQUIREMENTS
All electrical wiring must be performed by
A QUALIFIED LICENSED ELECTRICIAN
. Because of the heat involved in the sauna, it is
required that you use copper wire with 90ºC insulation. Do not use aluminum wire to make the connection. Consult with an
electrician so you can determine the requirements for your particular situation. All wiring must conform to all national, state and
local codes and regulations and according to the instructions provided with the heater.
LOCATING THE SAUNA
Your Bluestone Indoor Sauna was specifically designed to utilize your existing floor. As such, assembly is made very simple since the
entire sauna sits on pre
-
fabricated rails and risers rather than on an integral floor platform. Your sauna can be assembled on any
surface that is firm and flat, including concrete, ceramic, vinyl, laminate, or tile. (Installation on a carpeted surface is not recom-
mended.)
ASSEMBLY
You should use two people for the assembly of the Bluestone Sauna. The wall and roof sections are large and need two people to
lift and hold in place during assembly.
BASIC TOOLS
You should have the following tools:
Cordless drill for driving screws
1/8” drill bit
Stepladder or stool
Rubber Mallet
Claw hammer
Screwdrivers (Phillips and Flathead)
Framing Square
Utility knife
Level