10x Installation Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: February 7, 2007
Page 11
9 Data Network
The Local Area Network (LAN) and Wide Area Network (WAN) data network ports are 10BaseT/100BaseTX
auto-sensing and auto-MDI/MDIX ports.
The Allworx 10x is a sophisticated network appliance that must be properly configured before being connected
to the LAN and WAN.
Note: Do not plug any network cables into the server without first properly configuring the server. Failure to
heed this warning may result in a disruption of network connectivity with other equipment on the
network.
After the network is properly configured, the LAN and WAN network cables can be plugged in. Standard RJ-45
category 5 network cables must be used. The four LAN ports are all switched Ethernet ports and may be used
in any order.
The LED’s on the LAN and WAN ports are defined in Table 4.
LED Identification
State
Description
On 100Mbps
Left - Amber
Off 10Mbps
Off
No link: the network is not connected
On
Link: the network is successfully connected
Right - Green
Blinking
Activity: data is being transmitted or received
Table 4: Network Port LED Definitions
