KEENAN
MechFiber350 and 370 Operator’s Manual
10
Revision D01 21
st
May 2019
The following safety points are general guidelines. Given the wide variety of possible operating
conditions, other safety risks that are not listed here may exist.
a)
Always park the mixer wagon on level ground and apply the handbrake when not in use.
b)
Do not exceed 15 km/h (10 mph) when in use/transit. Local road traffic laws will apply
when machine is in transit on public roads, on which the maximum permissible speed is
25 km/h. Exceeding this will compromise the life and safety of major components, such
as the hitch, axle, wheels and chassis.
c)
Ensure the VFC-door is closed and all feed-out trays/elevators are in the
closed/transport position prior to using on a public road.
d)
When turning, exercise extreme caution for any potentially overtaking traffic on either
side.
e)
Do not stand on the ladder whilst the feeder is in transit.
The mixer wagon should never
be used for the transport of people, animals or objects.
f)
Do not stand between the tractor and mixer wagon while it is in use.
g)
Only use a PTO shaft with a properly fitted safety guard and the correct shear bolt.
h)
Always connect the PTO shaft with the shear bolt end to the machine. The operating
speed of the PTO is 540 rpm, and the direction of rotation is marked on the front cover.
Always use a well-maintained PTO shaft and keep the safety covers in good condition.
i)
Ensure all trailing leads, hoses, etc., are well clear of the PTO.
j)
Never operate the PTO in “ground speed mode” or drive the PTO in reverse.
k)
Make sure all covers/guards are fitted and closed correctly. Never remove guards when
the mixer wagon is connected to the tractor.
l)
Ensure that the mixer wagon and the immediate area surrounding it are clear of people,
especially children, before commencing operation. Ensure that there is sufficient
visibility for the operator to observe all danger zones and that the tractor is equipped
with mirrors to enable the operator to see both sides of the machine while it is in
operation.
m)
When connecting the tractor to the mixer wagon, only connect using the ring hitch/hitch
on the mixer wagon to ensure safe coupling. Ensure that the hitch is connected properly
to the tractor and that all pins and clips are properly installed. Then, connect the PTO
shaft in the correct fashion. Connect the hydraulic hoses, ensuring that the functions
match the indicated valve on the tractor.
n)
When disconnecting, always ensure that a stand or jack is used to secure the mixer
wagon in the park position and that the handbrake is properly applied. Before driving
the tractor away from the mixer wagon, ensure that all hoses and cables are
disconnected.
