All
SportSystems, Inc.
©
2021
Step 2 - Add eye and trim cable to proper length
Complete cable assembly by first determining the proper length of the cable, forming the eye and then
trimming off extra cable. Follow the steps below …
(1)
Open Turnbuckle fully as
shown below. Both end fittings
of the turnbuckle should be
extended as far as possible
without coming out. This is
important to ensure that the
cable is cut to the proper length
and for providing enough
tension on the cable after it is
attached to the cable.
(2a) Determine Proper Cable
Length
for
SideRite™ Cables
,
wrap cable around the top and
then the bottom depth poles for
each SideRite™ Cables. Pull
the end of the cable through
the hooked end of the
turnbuckle until cable is tight.
Mark the cable to indicate
where the eye should be
formed.
(2b) Determine Proper Cable
Length
for
ShotDefender™
Cables
, wrap cable around the
top-left and top-right depth
poles (across the entire width).
Pull the end of the cable
through the hooked end of the
turnbuckle until the cable is
tight. Mark the cable to
indicate where the top of the
eye should be formed.
(4)
Thread two wire clips on to
the cable and form a loop in the
cable around the hook end of
the turnbuckle.
(5)
Thread the dead end of the
cable back through the wire
clips. Tighten wire clips with
wrench.
(6)
TRIM extra cable and
tighten turnbuckle to provide
tension on the cable.
Page 34 of 35
Last Revised 6/7/22
