Chapter 6: Deploying the SG-9100
Allot SG-9100 Hardware Guide
6-4
Configuration
Active redundancy can be configured on the Service Gateway either via the NetXplorer
GUI or via AOS CLI.
Via NetXplorer GUI
To configure Active Redundancy:
Log into the NetXplorer
Select the Service Gateway you wish to configure in the
Navigation Pane.
Right-click the Service Gateway and select
Configuration
from
the drop down menu.
OR
Click the
Configuration
button in the Toolbar.
Open the
Networking
tab and set the
Redundancy Mode
to
Active
.
Confirm that the
Enable Bypass Unit
checkbox is not selected.
Click
Save
. The system will reboot.
After rebooting, you can view the changes from the Configuration tab.
For more information concerning Service Gateway configuration via NetXplorer, see
the
NetXplorer Operation Guide
.
Via AOS CLI
To configure Active Redundancy:
Log into the Service Gateway and enter the following commands:
To disable the bypass unit:
go config network -bypass_unit disable
To set redundancy mode:
go config network -redund_mode active
NOTE
There is no need to change the port usage settings after running the
previous command for enabling active-redundancy the port usage
for the cloned ports will be set automatically.
go config network -redund_mode standalone
