Allnet ALL-WAP0305AC, Manual

Page: 15 / 110

Mounting the ALL-WAP0305AC
You may use either one as the power source. Do NOT use both at the same time.
2. Drill a 37 mm deep 8 mm hole in the markings and hammer the bolts into the openings.
Using the provided hardware, the ALL-WAP0305AC
can be attached to a wall or a pole.
To attach the ALL-WAP0305AC to a wall using wall mounting kit.
3. Place the lock and flat washers on
the four hex cap screws and drive the screws to attach the bracket to the back of the Access Point.
1. Mark the four locations of the mounting holes on the
flat mounting surface.
4. Tighten the flat washers to secure the bracket to
the
16