Allmand Night-Lite E Series, Operator'S Manual

Page: 9 / 64

9
en
Figure 3
M
J
K
N
O
P
Q
L
Ref Description
J Photocell
K Level
L Control Panel Door / Latch
M Tower Light Switches (4 qty)
N Light Operation Mode Switch
O Main Circuit Breaker
P Timer Module
Q 120-Volt Power Inlet
Preparing The Portable
Light Tower For Use
If the unit has been stored or idle for
a period of time, follow these steps to
prepare the portable light tower for use.
WARNING
Operating a machine with worn, dam-
aged or missing parts can result in
death or serious injury. Always replace
worn, damaged or missing parts
promptly. Do not operate this machine
until all worn, damaged or missing
parts have been replaced, and proper
operation of the machine has been
verified.
NOTICE
The use of authorized replacement
Allmand parts is encouraged. The war-
ranty does not cover damage or perfor-
mance problems caused by the use of
parts that are not authorized replace-
ment parts.
1. Check that a copy of the Operator’s
Manual is with the portable light tower
(on the inside of the control panel
door).
2. Check that all safety decals are leg-
ible and in place on the portable light
tower. See Safety Decals in the
Operator Safety section.
3. Check that the outriggers and jacks
operate properly, and that each one
is secured in the transport position.
See Leveling and Stabilizing the
Light Tower in the Operation sec-
tion.
4. Check that each of the light fixtures
illuminates properly. See Operating
The Tower Lights in the Operation
section.
5. Check that the light tower mast raises
and lowers properly. See Raising
and Lowering the Light Tower
Mast .
Transporting
Transport Position
Before transporting, make sure that the
portable light tower is in the transport
position (Figure 4):
1. Lower the light tower mast complete-
ly. See Raising and Lowering the
Light Tower Mast .
2. Place the outrigger jacks in the
stowed position. See Stowing
Outriggers and Jacks . Make sure
that the jacks are rotated so that the
jack foot is toward the center of the
unit.
3. Align the light tower mast tab with the
indicator decal on the right side of the
unit. Tighten the light tower mast lock
Not for
Reproduction