Camera interfaces
85
Mako G Technical Manual V4.2.2
Test conditions
Output: external 2.4 k
resistor to GND, Isolated Out Power set to 12 V.
Control signals
The inputs and outputs of the camera can be configured by software. The different
modes are described below. All input and output signals that pass the I/O
connector are controlled by the I/O strobe commands.
Input block diagram
Output signals
Output signals are configured by software. Any signal can be placed on any output.
The main output signals are described below:
•
Higher external values increase the times in table 41 above.
•
It is recommended to trigger on the rising edge. This guarantees the fastest
possible reaction time.
Figure 41: Input block diagram
Signal
Description
GPO
Configured to be a general purpose output, control is assigned to
SyncOutGpoLevels.
AcquisitionTriggerReady
Active once the camera has been recognized by the host PC and is ready to
start acquisition.
FrameTriggerReady
Active when the camera is in a state that will accept the next frame trigger.
Table 42: Output signals
Polarity
selectable
via so
Ō
ware
Input state
Input signal
Optocoupler
LP
Į
lter
