Installing the camera
103
Alvium USB Cameras User Guide V3.1.3
Mounting the camera
Mounting bare board cameras
Schematic drawings in
show Alvium USB bare board cameras. Only the
mounting area (gray) can be used for mounting. The sensor and electronics area
(red) must not be touched nor put at mechanical stress.
a = Mounting hole
b = Mounting hole and chassis ground
Mount the bare board with four M2 screws at 0.1 Nm maximum torque.
Mounting areas for Alvium USB 90° models are the same as for standard models.
Heat dissipation and electromagnetic compatibility for bare board cameras
For heat dissipation, see the Optimum Heat Dissipation for Housed Alvium Cameras
application note.
For electromagnetic compatibility, see the Electromagnetic Compatibility for Open
Housing Alvium Cameras application note.
See
www.alliedvision.com/en/support/technical-documentation/
under Additional documents
.
NOTICE
Damage to the camera by improper mounting
•
Allow mechanical contact only at the mounting area.
•
Avoid any mechanical stress to the sensor and the electronics area.
•
Avoid short circuits of the electronics components.
•
Give 2 mm minimum clearance above board components.
•
Tighten screws at 0.1 Nm maximum torque.
Figure 39: Mounting area of Alvium USB bare board cameras
connector side (left); sensor side (right)
i
b
a
a
a
b
a
a
a
Top
