16
GS950PS V2 Series Quick Installation Guide
3. Plug the other end of the power cord into an appropriate AC
power source.
4. Wait two minutes for the switch to start its management software.
5. Verify that the POWER LED is green. If the LED is off, see
Starting the First Management Session
This procedure explains how to start the first management session on
the switch. The procedure assumes that your network has a DHCP
server.
Note:
For instructions on how to start the first management session
in a network without a DHCP server, refer to the
GS950PS V2
Gigabit Ethernet Switch Series Installation Guide
. The guide is
available at
www.alliedtelesis.com/us/en/services-support
.
1. Assign the switch an IPv4 address on the DHCP server on the
network. (The MAC address of the switch is provided on a label
on the rear panel.)
2. Connect at least one port on the switch to a network device, such
as another Ethernet switch.
3. Power on the switch. Refer to “Powering On the Switch” on
4. Wait two minutes. The switch start its management software and
obtains its IPv4 address from the DHCP server.
5. Start the web browser on your workstation.
6. Enter the IPv4 address of the switch in the URL field of the
browser. This is the IPv4 address you assigned the switch on the
DHCP server.