GS950PS V2 Series Quick Installation Guide
11
Here are the items for installing the switches on a wall:
Two brackets and eight screws (included with switch)
Four wood or concrete wall screws and washers. The switch
comes with four 3.5x16mm screws and washers.
Four wall anchors. The switch comes with four 4x22.2mm
anchors.
Cross-head screwdriver (not provided)
Flat-head screwdriver (not provided)
Stud finder for a wooden wall, capable of identifying the middle of
wall studs and hot electrical wiring (not provided)
Drill and 1/4” carbide drill bit for a concrete wall (not provided)
To install the switch on a wall, perform the following procedure:
1. Place the switch on a table.
2. If the four bumper feet are attached to the bottom of the switch,
remove them with a flat-head screwdriver.
3. Install the two brackets to the sides of the unit with the eight
screws included with the switch.
Warning:
The device should be installed on the wall by
a qualified building contractor. Serious injury to yourself
or others or damage to the equipment may result if it is
not properly fastened to the wall.
E105
Caution:
The supplied screws and anchors might not be
suitable for all walls. A qualified building contractor
should determine the hardware requirements of your
wall before installing the switch.
E88