Broadcom Advanced Control Suite 3 User’s Guide
69
Note
The maximum number of team members is 8.
Note
When team configuration has been correctly performed, a virtual
team adapter driver is created for each configured team.
Note
If you disable a virtual team and later want to reenable it, you must
first disable and reenable all team members before you reenable the
virtual team.
Note
When you create Generic Trunking and Link Aggregation teams,
you cannot designate a standby member. Standby members work
only with Smart Load Balancing and Failover and SLB (Auto-
Fallback Disable) types of teams.
Note
For an SLB (Auto-Fallback Disable) team, to restore traffic to the
load balance members from the standby member, click the Fallback
button on the Team Properties tab.
Note
When configuring an SLB team, although connecting team members
to a hub is supported for testing, it is recommended to connect team
members to a switch.
Note
Not all network adapters made by other vendors are supported or
fully certified for teaming.
16. Configure the team IP address.
a. From the
Control Panel
, double-click
Network Connections
.
b. Right-click the name of the team to be configured, and then click
Properties
.
c. On the
General
tab, click
Internet Protocol (TCP/IP)
, and then
click
Properties
.
Summary of Contents for Broadcom Advanced Control Suite 3
