Allied Telesis AT-x950-28XSQ, Installation Manual, Page: 141 / 190

AT-x950-28XSQ Switch and VCStack Installation Guide
141
Verifying the
Member Switch
Perform the steps in Table 20 to confirm the configuration of the member
switch.
13 Wait two minutes for the switch to initialize its management software.
14 Go to “Verifying the Member Switch,” next.
Table 19. Configuring the Member Switch - Part II (Continued)
Step Description and Command
Table 20. Verifying the Configuration of the Member Switch
Step Description and Command
1 Start a local management session. Refer to “Starting a Local Management Session” on
page 127.
2 Move to the Privileged Exec mode.
awplus> enable
3 Enter the SHOW STACK command and check the display for the following:
- The table should have two switch entries, with the IDs 1 and 2.
- Switch ID 1, with its empty fields, is for the provisioned master switch.
- Switch ID 2 is for the member switch. It has the “Active Master” role now, but that
changes when you power on the stack. If the table does not include this switch,
repeat “Configuring the Member Switch - Part I” on page 137. Be sure to perform the
STACK RENUMBER command and to save your changes with the WRITE
command.
- The member switch should have priority 2. If it does not, repeat “Configuring the
Member Switch - Part II” on page 139. Be sure to perform the STACK PRIORITY
command.
- The Operational Status should be Standalone Unit to indicate that stacking is enabled
and that the unit is operating as a stack of one switch. If the status is Stacking
Hardware Disabled, the stacking feature is disabled. Repeat “Configuring the
Member Switch - Part I” on page 137. Be sure to perform the STACK ENABLE
command and to save your changes with the WRITE command.
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID MAC address Priority Status Role
1 - - - - Provisioned
2 - e01a.ba56.c112 2 Ready Active Master
Operational Status Standalone unit
Stack MAC address 0000.ab56.478c (Virtual MAC)