Allied Telesis AT-SBx81CFC960, Installation Manual

Page: 292 / 324

Chapter 15: Building a Stack
292 Section III: Building a Stack with VCStack Plus
Note
If the chassis has two controller cards, the active controller
automatically activates the VCStack Plus feature license on the
standby controller.
After you enter the command, the switch displays the prompt in
Figure 172:
Figure 172. LICENSE Command
2. Type Y for yes to activate the license on the controller card. (This does
not reset the chassis or modules. You will reboot the chassis later in
these instructions.)
If the chassis has two controller cards, the active controller card
automatically shares the VCStack Plus feature license with the
standby card and displays the messages in Figure 173.
Figure 173. LICENSE Command Message with Two Controller Cards
If the chassis has only one controller card, the controller card displays
the message in Figure 174.
Figure 174. LICENSE Command Message with One Controller Card
3. Go to “Enabling the Stacking Feature” on page 293.
A restart of affected modules may be required.
Would you like to continue? (y/n)
Card 1.5 installed 1 license
Card 1.6 installed 1 license
2 licenses installed
Card 1.5 installed 1 license
1 license installed