
iv
Electrical Safety and Installation Requirements
INSTALLATION
LIGHTNING DANGER
DANGER
: DO NOT WORK on equipment or CABLES during periods of LIGHTNING
ACTIVITY.
CAUTION
: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO DE-ENERGISE
EQUIPMENT disconnect the power cord.
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the
label.
ELECTRICAL—TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly
wired earth ground socket outlet. An improperly wired socket outlet could place
hazardous voltages on accessible metal parts.
ELECTRICAL—CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 6 amp minimum, 250V, made of
HAR cordage molded IEC 320 connector on one end and on the other end a plug
approved by the country of end use.
MOUNTING INSTRUCTIONS
CAUTION
: These models are designed for operation in the HORIZONTAL position.
VERTICAL MOUNTING must NOT BE DONE without the use of an Allied Telesyn
vertical mount chassis designed for this purpose.
CAUTION
: Air vents must not be blocked and must have free access to the room
ambient air for cooling.
OPERATING TEMPERATURE
This product is designed for a maximum ambient temperature of 50 degrees C.
ALL COUNTRIES
: Install product in accordance with local and National Electrical
Codes.
NORMEN
: Dieses Produkt erfüllt die Anforderungen der nachfolgenden Normen.
Hochfrequenzstörung
EN55022 Klasse B
Störsicherheit EN50082-1
Elektrische Sicherheit
EN60950, UL1950, CSA 950
Laser EN60825
SICHERHEIT
ACHTUNG
: GEFÄHRLICHE SPANNUNG
Das Gehäuse nicht öffnen. Das Gerät enthält keine vom Benutzer wartbaren Teile. Das
Gerät steht unter Hochspannung und darf nur von qualifiziertem technischem
Personal geöffnet werden. Vor Anschluß der LAN-Kabel, Gerät vom Netz trennen.
Das ist ein “LED Produkt der Klasse 1”
INSTALLATION
GEFAHR DURCH BLITZSCHLAG
GEFAHR
: Keine Arbeiten am Gerät oder an den Kabeln während eines Gewitters
ausführen.
Summary of Contents for AT-MS201
