Chapter 1: Overview
22
Twisted-Pair Port
Here are the basic features of the twisted-pair (copper) port:
IEEE 802.3u Auto-Negotiation compliant
Auto MDI/MDI-X
100 meters (328 feet) maximum operating distance
RJ45 connector
The twisted-pair port features an eight-pin RJ45 connector that
uses four pins at 10 or 100 Mbps and all eight pins at 1000 Mbps.
For the port pinouts, see “RJ45 Connector and Port Pinouts” on
Note
For twisted-pair port cabling specifications, refer to Table 7 on
Auto
MDI/MDI
-
X
An RJ45 twisted-pair port on a 100 Mbps Ethernet network device can
have one of two possible wiring configurations: MDI or MDI-X. The RJ45
port on a PC, router, or bridge is typically wired as MDI, while the
twisted-pair port on a switch or hub is usually MDI-X.
The media converter features Auto MDI/MDI-X. The twisted-pair port
automatically determines the configuration of the port on the device to
which it is connected and then configures itself appropriately.
For example, if a port on a media converter is connected to a port on a
bridge, which is typically wired as MDI, the port on the media converter
automatically configures itself as MDI-X.
This feature allows you to use a straight-through cable when connecting
any type of device to the media converter, regardless of the wiring
configuration of the port on the device.
Auto-Negotiation
or 100 Mbps
Full-Duplex
Mode
You can set the twisted-pair port to 100 Mbps full-duplex mode or
Auto-Negotiation mode using the PORT 1 (right) DIP switch on the rear
panel. See Figure 6 on page 19.
When this DIP switch is in the FORCE 100 F/D (up) position, the
twisted-pair port is forced to 100 Mbps full-duplex mode, and Auto
Negotiation is disabled.
Note
For the AT-MMC2000/T model, when the PORT 1 DIP switch is in
the FORCE 100 F/D (up) position,
both
port 1 and port 2 are forced
to 100 Mbps full-duplex mode.
Summary of Contents for AT-MMC200/LC
