Chapter 3: Turn-Up and Troubleshooting
AT-iMG2400 Series Installation Guide
30
Solution 3
: Verify the configuration. If problems persist, reset the iMG to its factory defaults. Use the
command sequence
>system
(to enter the Privileged Exec Mode),
>configure terminal
(to enter
the Global Configuration Mode), and then
>boot config-file default.cfg
If problems still
persist, contact Allied Telesis.
Problem:
There is a problem with the telephone service.
Solution:
Check the following:
Swap out the cable for a known good cable.
For POTS phones and fax machines, verify that the dial mode for the telephone and fax
are correct, according to the manual that was supplied with the telephone or fax.
Check the telephone or fax machine for problems.
Note
If you need further assistance, please contact Allied Telesis Technical Support. Refer to “Contacting
Allied Telesis” on page 10.
