AT-FH705E Installation Guide
7
Problem 3:
Port 1 does not operate properly.
Solution 3:
The Uplink slide switch may be in the wrong position. Check the following:
‰
When using the cascade port of the hub (Port 1), you should set the slide
switch to the
8SOLQN
ý
position.
‰
When cascading two hubs, the unit using the cascade port should have
the button set to the
8SOLQN
position, while the other unit should have its
switch set
WR
ý
1RGH
.
‰
When port 1 is used to connect to a workstation or other equipment, you
should set the slide switch to the
ý
1RGH
position.
Problem 4:
There is data loss between the hub and one of the attached network nodes.
Solution 4:
‰
Make sure that the cable length between the hub and the connected
network device is no greater than 100 m (328 ft).
‰
Make sure you are using Category 5 cable.
