AT-8350GB Installation Guide
67
Cabling the Switch
Perform the following procedure to connect the data cables to the
switch ports. Refer to
Required Cables
on page 55 for cable
specifications.
1. Connect the twisted pair data cables to the RJ-45 ports on the switch,
as shown in Figure 39.
Figure 39
Connecting the Twisted Pair Data Cables
When connecting a twisted pair cable to a port on the switch,
observe the following guidelines:
An RJ-45 connector should fit snugly into the port on the switch.
The tab on the connector should lock the connector into place.
Do not connect a port on the switch to a phone jack. Doing so can
damage the switch.
Since the RJ-45 ports on the switch are auto-MDI/MDI-X, you can
use either straight-through or cross-over twisted pair cables to
connect the network devices.
If your network topology will contain a loop where two or more
network devices can communicate with each other over more
than one data path, do not connect the network cables forming
the loop until after you have activated the Spanning Tree Protocol
(STP) on the switch. Data loops can adversely affect network
performance. For instructions on how to activate STP, refer to the
AT-S41 Management Software User’s Guide for the AT-
8350GB Switch
.
15
13
11
9
10
12
14
18
17
19
21
23
25
26
24
22
20
8
Summary of Contents for AT-8350GB
Page 1: ...Fast Ethernet Switch AT 8350GB Installation Guide PN 613 50307 00 Rev B...
Page 4: ...4...
Page 82: ...Installation 82...
Page 88: ...Troubleshooting 88...
