Water Connection Requirements
WARNING
To prevent personal injury, avoid contact with inlet
water temperatures higher than 125° Fahrenheit [51°
Celsius] and hot surfaces.
W748
NOTE: For 8 kg / 20 lb. / 80 L, 11 kg / 25 lb. / 105 L, 14
kg / 30 lb. / 135 L, 18 kg / 40 lb. / 180 L and 24 kg / 55
lb. / 240 L Models, to connect cold water, use a hose
with plastic elbow. To connect hot water, use a hose
with metal elbow.
Do not re-use water hoses; only use new water hoses.
The appliance has been designed with a built-in "AB" airgap sys-
tem according to EN1717. Nevertheless, when potable water will
be connected to the appliance, an approved double check valve or
some other no less effective device providing backflow preven-
tion protection to at least fluid category three shall be fitted at the
point of connections between the water supply and the appliance.
All intake connections to the machine are to be fitted with man-
ual shut-off valves and filters, to facilitate installation and servic-
ing.
All water connectors present on the machine must be connected
or the wash program will not function correctly. Refer to
Table 9
for possible connection options, which will depend on the water
types to be connected to the machine, which can be found by
checking the machine plates.
2 Water Connection Models
CHM2475N_SVG
2
1
1.
Refer to
Table 9
.
2.
Refer to
Table 9
.
Figure 15
3 Water Connection Models
CHM2476N_SVG
3
2
1
1.
Refer to
Table 9
.
2.
Refer to
Table 9
.
3.
Refer to
Table 9
.
Figure 16
Water
type
Water connection
1
2
3
Cold and Hot
Cold
Hot
N/A
Cold soft,
Cold hard and
Hot
Cold soft
Hot
Cold hard
Table 9
WARNING
If the water pressure is below the minimum value,
the wash result can not be guaranteed for a selected
program.
W914
The maximum water inlet temperature for vended models is
194°F [90°C]and the recommended maximum water inlet tem-
perature for on-premises models is 150°F [66°C] (standard mod-
els) or 140°F [60°C] (WRAS approved models) .
Connections should be supplied by a hot and a cold water line of
at least the sizes shown in Water Supply Line Sizing . Installation
of additional machines will require proportionately larger water
lines.
Connections should be supplied by a hot and a cold water line per
national and local codes and in accordance with IEC 61770.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
30
Part No. D1634ENR4
Summary of Contents for WMA103E ARIES
Page 2: ......
