To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
92
802748
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 8
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
48. Cabinet Leveling Legs
a. Place unit in position on a solid, sturdy and
level floor. Installing the unit on any type of
carpeting, soft tile, a platform or other weakly
supported structures is not recommended.
b. Place a level on the cabinet top and check if
unit is level from side to side and front to
back.
NOTE: Level must be on a raised portion of top
panel. Refer to
Figure 13
.
c. If unit is not level, tilt unit to access front and
rear leveling legs. For easier access to
leveling legs, prop up unit with wooden
block.
d. Loosen locknuts and adjust the leveling legs
until the unit is level from side to side and
front to back (using a level). Make sure unit
does not rock
. Refer to
Figure 13
.
e. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
f. Place rubber feet on all four leveling legs.
Refer to
Figure 13
.
g. Verify unit doesn’t rock.
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Figure 13
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION
SW
Leveling
Leg
Level
Washer
Base
Locknut
Rubber
Foot
SWD796N
